DIY Motorcycle Garage Door Opener Remote -

If you don’t want to spend a lot of money to buy remote openers for your motorcycle. Here is a quick tutorial about how to build a garage door opener for your motorcycle.

You will need a remote garage door opener & a WATERPROOF momentary push button

I used Chamberlian Clicker as it is thin in size and it can slide or stick to any plastic pocket you have in your motorcycle.

On top corners, you will see 4 pins on both sides, these are pins where we will solder the wires to connect push button switches.

I am using only 1 port for 1 door

I made a tiny hole through the back cover so the wires sit tight and they are not accidentally pulled while moving around the remote. The other end of the cable gets connected to the push button which has 2 connectors.

THAT’S IT – YOU HAVE A PUSH-BUTTON GARAGE DOOR OPENER FOR YOUR MOTORCYCLE. YOU CAN FIT IT IN THE FAIRING OR SIDES.

THIS IS FOR 2018+ GOLDWING MOTORCYCLES

2018+ Goldwings have small plastic space available on the left and right sides of the bike. I drilled a hole for the switch/push button and slid the remote on the inside of the fairing.

GOOD LUCK!!!